How to Reset and Reconnect Your MyQ/LiftMaster Garage Door Opener to Wi-Fi

1. Locate the Adjustment Button

• LiftMaster Overhead Openers: The black adjustment button is located between the up and down arrow buttons on the back of the unit.

• Wall-Mounted LiftMaster Openers: The button is under the front cover.

• myQ Smart Garage Hub: The settings button is located on the side of the hub.

2. Clear Wi-Fi Settings

• For Garage Door Openers:
  Press and hold the black adjustment button until the Wi-Fi LED turns off or you hear three beeps.

• Press the yellow button three times, you should hear three beeps and it will flash blue.

• For myQ Smart Garage Hub:
  Press and hold the settings button until the blue LED starts flashing. Then immediately press and hold it again until the LED pauses or a beep is heard.

3. Connect to the MyQ Device
Using a smartphone or other Wi-Fi-capable device:

• Go to your list of available Wi-Fi networks.

• Select the network that begins with "MyQ" — this is your MyQ device.

4. Open Web Browser and Access Setup Page

• Once connected to the MyQ network, open your web browser (e.g., Safari or Chrome).

• Type setup.myqdevice.com into the address bar.

• This will take you to the MyQ Wi-Fi Setup page.

5. Complete the Setup

• Follow the on-screen instructions to connect your device to your home Wi-Fi network and complete the setup process.